In Stock Unsealed 6355 BLDC Motor 8mm Shaft for Fighting Robots Electric Skateboard Go Kart
If you want to use other cheaper but slower shipping method, please contact shelly@mayrc.com
Shipping time by DHL or UPS is fast, normally 3-7 days arrive to you.
Maytech Brushless 6355 170KV 8mm Shaft Unsealed Cover Outrunner Sensored Motor Great Heat Dissipation for Esk8/Robotics/E-bike/E-scooter/Mountainboard/Offroad Board
|
Model No
|
MTO6355-HA
|
KV
|
170, email to shelly@mayrc.com if you want other KV
|
|
Idle Current
|
0.8A
|
Max Current
|
65A
|
|
Inpur Voltage
|
3-12s Lipo (12-50V)
|
Max Output Watt
|
3510W
|
|
Shaft Dia
|
8mm |
Output Shaft Length
|
26mm |
If you want other KV, please email to shelly@mayrc.com
Notice:
The motor has upgraded hall sensor embedded into stator, hall sensor board is more stable and motor has more precise positioning and smoother startup.
Printing on the motor case also has updated to with CE & ROHS symbol.
The upgraded version can work with previous version in same KV.

New embeded hall sensor version VS old version:
1. New version is with embedded hall sensor to stator:
Hall sensor board is more stable and motor has more precise positioning and more smooth starup.
2. With changing the hall sensor position, inside space is bigger than before and the original small bearing inside the stator can be replaced with a larger model, which increases the lifetime of the motor.
3. Mounting holes are updated to 8x M4 with deeper thread 11mm. Motor installation will be firmer.













Stock Notice Before Place Order:
1. The motor 170KV and 70KV are stock item, but stock is limited, so please confirm your order asap, or please contact us shelly@mayrc.com to check stock first if you need very urgently.2. Shipping time is about 24 working hours after your order confirmed if the product you ordered is in stock, if not in stock, lead time is about 30-40 days.
3. Motor wire leads out position is specific, if wind one more circle or one less circle, the KV would differ much, hard to make exact KV, so each motor might has ±5%-10% tolerance, this is normal.
Motor Drawing:






